WORKSHOP 8

How to wrap Point Crystal

How to wrap a point crystal

Preparation

✵waxed cord

✵your selection of a point crystal

Option

✵Beads ( make sure two waxed cords can fit through the hole)

Step 1

Cut four waxed cords into 75cm each and separate to two groups folding in half like the picture

Step 2

Put one group of cords underneath of the other group

Step 3

lift up one side like the picture to make a loop hole

Step 4

pull the other ends into the loop to make a knot

This knot is called a Lark’s Head Knot

Step 5

place the knot on the crystal to see where you want the front of pendant to be.

Step 6

Check the size of the crystal

Step 7

Keep that size of the crystal in your mind and Make a knot

Step 8

Put the crystal back in

Step 9

Spread cords into two sides

Step 10

make knots on both side

Step 11

Make a knot on front side

Step 12

Make a knot on the back too

Step 13

Hold the crystal firmly, and pull all cords to make it very tight.

Step 14

Spread the cords as in the picture.

Two cords each from the front and back to the sides and leave the others straight.

Step 15

Start making Flat knots using the outside cords as working cords

Step 16

Leave two working cords and continue flat knots with the other two working cords.

Make a belt about 1.5-2cm long

Step17

Fold the belt to the front side to make a loop(hook)

Step 18

Use all of four working cords to make few flat knots to secure the loop(Hook)

Step 19

Make a one simple knot with working cords to make it very tight

Step 20

Cut off left over of working cords

You may also cut the other cords and finish it or continue the next steps for creating a little design on the front…

Option to create a little design at the front

Now you should have four cords(ABCD) as a picture.

Step 21

Make a double hitch knot with cord C & D

Please check our previous workshop 5 & 7

Step 22

Make a double hitch knot on cord C with A, and on cord D with B.

Step 23

Put a bead through the cords A & B, and make a double hitch knot with cord A on cord d, and with cord B on cord C

Step 24

make a double hitch knot with Cord D & C

Step 25

Put cord D through a needle

Step 26

Pull needle through, underneath the knot on the crystal, as in the picture

Step 27

Thread cord C through the needle and repeat step 26

Now it’s all tied.

Step 28

Make knots on both sides and cut the left over to finish off.

Previous
Previous

Make your mala

Next
Next

Workshop 7 Micromacrame Pattern 1